Installation Instructions...
There is also an instructional video to walk you through the Installation of your Grillbrella on this website. The Grillbrella is box shipped to your doorstep. The package contains:
- The Main Unit, which comes folded for shipping
- The Base Unit
- Attachment screws
- Instructional Video
- Safety Guidelines
STEP 1
The main unit will need to be attached to the grill (or other structure). The main unit must be installed in the correct position. The bottoms of the mounts are marked with a T for top, and B for bottom. It is important to align these vertically.
Align the Main Unit as close to the front edge of your grill as possible. While holding the Main Unit, position it so that the swing arm will be clear of any side tray/table that are part
of the grill, and a minimum of 19" above ground to clear the Base Unit. Mark the side of the grill, through the holes in the mounting caps on the Main Unit.
STEP 2
The mounting screws provided are self-tapping; however you may pre-drill the marked holes, with a 1/8" metal drill bit, which will make the installation much easier. If you are going to drill, now you can drill the marked holes.
STEP 3
Using a ratchet or standard screw gun, attach the Main Unit to the Grille using the self-tapping tech mounting screws provided.
STEP 4
With the unit now attached, loosen the two unions, so that the umbrella support arm/tee can be swung out into an ideal position at the grill that you would be comfortable with during grilling.
Then hand tighten the two unions to secure the unit in place. The "optional" towel rack can also be swung into position and ready for a roll of paper towels.
STEP 5
Insert the two legs into the base unit, and secure with self-tapping screws similar to attaching the main unit to the grill. There should now be four legs.
Align the base unit directly under the main unit, so that the umbrella can be inserted into the main unit first, then down into the base unit.
STEP 6
Insert the umbrella (provided by others), into the main unit coupling, and down into the base unit. Once in place, hand tighten the set screws in both the main unit coupling and the base unit coupling, to secure the umbrella in place.
Umbrellas are also available on the web site for purchase.